Model: MTS200 (1U)
Doc. Ref. no. : m08/om/201
Issue no. : 03
User’s Manual
Page 64 of 195
Page 64 of 195
2. Go to option for which you want to configure default settings using LEFT/RIGHT arrow keys.
3. Press OK key.
4. Wait till "Configuring....." message is there on display. Message indicates device is saving new
configurations.
User need to take care while configuring any type of settings to default factory as the settings will affect
the already running particular communication such as SNMP, NTP, Network.
If user defaults the Network settings, the network settings of eth0 and eth1 such as IP Address, Subnet
Mask and gateway will go on factory default and hence affect other network services such as Telnet,
SSH, NTP, SNMP, Webserver.
User need to restart the particular Ethernet service such as NTP, SNMP if their settings are defaulted to
factory settings.
Note:
Settings will only become effective once user come out of configuration mode of keypad
menu to normal run mode.
RESTORE SETTINGS:
Here, user can restore previous settings of (GENERAL, ETHERNET, NTP and SNMP SETTINGS) once
they are done factory default by user. This mode will only restore previous settings before default.
For that just follow below steps :
1. Go to RESTORE SETTINGS menu using UP/DOWN arrow keys as shown in figure.
2. Go to option for which you want to configure restore settings using LEFT/RIGHT arrow keys.
3. Press OK key.
4. Wait till "Configuring....." message is there on display. Message indicates DEVICE is saving new
configurations.
User need to take care while configuring any type of settings to restore as the settings will affect the
already running particular communication such as SNMP, NTP, Network.
If user restore the Network settings, the network settings of eth0 and eth1 such as IP Address, Subnet
Mask and gateway will go on factory default and hence affect other network services such as Telnet,
SSH, NTP, SNMP, Webserver.
User need to restart the particular Ethernet service such as NTP, SNMP if their settings are restored to
factory settings.
Note:
Settings will only become effective once user come out of configuration mode of keypad
menu to normal run mode.
SYSTEM INFORMATION
This option displays the MTS200 device system version information.
