Model: MTS200 (1U)
Doc. Ref. no. : - m08/om/201
Issue no.: 03
Page 59 of 195
User’s Manual
*
: Cursor will start blinking once user enters this mode by pressing “OK” key, user can see blinking
cursor on 1
st
position of 2
nd
line. To change specific digit, use “UP” / “DOWN” arrow keys and to change
the position of blinking cursor use “LEFT” / ”RIGHT” arrow keys. UP/DOWN arrow keys will update the
digit on which cursor is blinking. User has to set " " for ending digits whenever changed IPv6 address
length is less than previous set IPv6 address.
After value is edited, press “OK” again to save the parameter or "ESC" to restore parameter value. After
user presses “OK” key, user can view changed IPv6 address and subnetmask at specific field in menu.
User can also configure only IPv6 subnetmask for specific port as shown in figure.
*
: Cursor will start blinking once user enters this mode by pressing “OK” key, user can see blinking
cursor on 1
st
position of 2
nd
line. To change specific digit, use “UP” / “DOWN” arrow keys and to change
the position of blinking cursor use “LEFT” / ”RIGHT” arrow keys. UP/DOWN arrow keys will update the
digit on which cursor is blinking.
After value is edited, press “OK” again to save the parameter or "ESC" to restore parameter value. After
user presses “OK” key, user can view changed IPv6 subnetmask.
7. ETH v6 GATEWAY
Her, user can configure IPv6 gateway for specific port as shown in figure. If AUTOCONF is ENABLE for
respective port, user cannot configure it.
*
: Cursor will start blinking once user enters this mode by pressing “OK” key, user can see blinking
cursor on 1
st
position of 2
nd
line. To change specific digit, use “UP” / “DOWN” arrow keys and to change
