Model: MTS200 (1U)
Doc. Ref. no. : - m08/om/201
Issue no.: 03
Page 57 of 195
User’s Manual
Her, user can configure IPv4 subnetmask for specific port as shown in figure. If DHCP is "ENABLE" for
respective port, this configurations will not affect IPv4 address.
*
: Cursor will s
tart blinking once user enters this mode by pressing “OK” key, user can see blinking
cursor on 1
st
position of 2
nd
line. To change specific digit, use “UP” / “DOWN” arrow keys and to change
the position of blinking cursor use “LEFT” / ”RIGHT” arrow keys. UP/DOWN arrow keys will update the
digit on which cursor is blinking.
After value is edited, press “OK” again to save the parameter or "ESC" to restore parameter value. After
user presses “OK” key, user can view changed IPv4 subnetmask.
4. ETH v4 GATEWAY
Her, user can configure IPv4 gateway for specific port as shown in figure. If DHCP is "ENABLE" for
respective port, this configurations will not affect IPv4 address.
*
: Cursor will start blinking once user enters this mode by pressing “OK” key, user can see blinking
cursor on 1
st
position of 2
nd
line. To change specific digit, use “UP” / “DOWN” arrow keys and to change
the position of blinking cursor use “LEFT” / ”RIGHT” arrow keys. UP/DOWN arrow keys will update the
digit on which cursor is blinking.
After value is edited, press “OK” again to save the parameter or "ESC" to restore parameter value. After
user presses “OK” key, user can view changed IPv4 gateway.
5. ETH v6 AUTOCONF
Here, user can configure autoconfiguration mode for IPv6 adressing for specific port. By setting it as
"ENABLE", user is configuring respected Ethernet port to receive IPv6 address from network
