Model: MTS200 (1U)
Doc. Ref. no. : m08/om/201
Issue no. : 03
User’s Manual
Page 84 of 195
Page 84 of 195
8
Eth1 IPv6 Netmask
0 to 128
This is v6 format subnet mask address
for eth1 port.
Default: 0
9
Eth1 IPv6 Gateway
Valid
IPv6
address
This is v6 format gateway address for
eth1 port.
Default: ::
Below table provide each parameter description for Ethernet network Services.
Command Parameter
Applicable
Value
Description
1
Telnet Service
0 / 1
Disable(0) or enable(1) telnet service
in MTS200. This change will make
telnet service effective on both eth0 &
eth1 port.
Note:
Service can be restarted only
though Option “4” in Network main
menu.
Default: 1
2
HTTP Service
0 / 1
Disable(0)
or
enable(1)
HTTP
Webserver service in MTS200. This
change will make HTTP service
effective on both eth0 & eth1 port.
At a time, either HTTP or HTTPS will
be active. If HTTPS was set previously
and user set HTTP enable, then
HTTPS will automatically be disabled
internally.
Note:
Service can be restarted only
though Option “4” in Network main
menu.
Default: 1
3
HTTPS Service
0 / 1
Disable(0)
or
enable(1)
HTTPS
Webserver service in MTS200. This
change will make HTTPS service
effective on both eth0 & eth1 port.
At a time, either HTTP or HTTPS will
be active. If HTTP was set previously
and user set HTTPS enable, then
HTTP will automatically be disabled
internally.
Note:
Service can be restarted only
though Option “4” in Network main
menu.
Default: 0
4
SNMP Service
0 / 1
Disable(0) or enable(1) SNMP service
in MTS200. This change will make
SNMP service effective on both eth0 &
eth1 port.
Note:
Service can be restarted only
though Option “4” in Network main
menu.
Default: 0
