Model: MTS200 (1U)
Doc. Ref. no. : - m08/om/201
Issue no.: 03
Page 189 of 195
User’s Manual
1) IP address of GPS ethernet port and telnet device should be same network domain.
2) Please verify the Ethernet connection between GPS ethernet port and telnet device by
pinging the IP address of GPS ethernet port. If IP address of GPS ethernet port is not
reachable, telnet connection will fail.
3) Provide correct IP address of GPS Ethernet port while trying to establish telnet connection.
Refer manual Appendix E for procedure for telnet connection with GPS Ethernet port.
4) Telnet service should be ON/START in MTS200 unit.
5) Telnet service should be ON in PC from which telnet session is required with MTS200.
6) Enter correct password of MTS200 when prompted for password filed while starting telnet
session with MTS200. Refer section 13.1 for details.
17.15 Cannot establish SNMP communication
1) IP address of GPS ethernet port and SNMP manager should be in the same network domain.
2) Please verify the Ethernet connection between GPS ethernet port and SNMP manager by
pinging the IP address of GPS ethernet port. If IP address of GPS ethernet port is not
reachable, SNMP connection will fail. Refer troubleshooting index 17.10 and 17.11.
3) SNMP Manager should be able to work on SNMPv1 and SNMPv2c protocol.
4) MIB file at manager side for model MTS200 agent should be the same provided at the time of
commissioning.
5) Read or Write Community of SNMP manager and model MTS200 agent should be same.
17.16 Not able to receive SNMP traps
1) IP address of GPS ethernet port and SNMP manager should be in the same network domain.
2) Please verify the Ethernet connection between GPS ethernet port and SNMP manager by
pinging the IP address of GPS ethernet port. If IP address of GPS ethernet port is not
reachable, SNMP connection will fail. Refer troubleshooting index 17.10 and 17.11.
3) SNMP version should not be set as 0 in MTS200.
4) SNMP Manager version should be as per set in MTS200 snmp settings.
5) SNMP manager IP should be configured in model MTS200 agent.
6) Trapenable for respective SNMP Manager Variable should be enabled in MTS200.
7) After doing any modification, restart SNMP service in MTS200.
8) Trapcommunity name and Manager IP address should be same at MTS200 and manager
side for Manager to receiver traps.
9) User need to configure PC snmptrapd.conf file for authentication disable or enable and
trapcommunity settings if required for v1, v2 and v3.
17.17 Not Able to set SNMP parameter
1) IP address of GPS ethernet port and SNMP manager should be in the same network domain.
2) Please verify the Ethernet connection between GPS ethernet port and SNMP manager by
pinging the IP address of GPS ethernet port. If IP address of GPS ethernet port is not
reachable, SNMP connection will fail.
3) SNMP version should not be set as 0 in MTS200.
4) SNMP Manager version should be as per set in MTS200 snmp settings.
5) For SNMPv3, authentication parameters should be correct at MTS200 and Manager side.
6) User need to configure PC snmptrapd.conf file for authentication disable or enable and
trapcommunity settings if required for v1, v2 and v3.
7) MIB file at manager side for model MTS200 agent should be the same provided at the time of
commissioning.
8) Write Community of SNMP manager and model MTS200 agent should be same.
17.18 Cannot establish SSH communication
