Model: MTS200 (1U)
Doc. Ref. no. : m08/om/201
Issue no. : 03
User’s Manual
Page 98 of 195
Page 98 of 195
9.2.6
Default / Restore Settings:
MTS200 settings related to General settings, NTP settings, SNMP Settings and Ethernet network settings
can be resetting to factory default and/or restore using “D” or “d” command in console based configuration
utility. User can restore last settings if user has done factory default and want to revert to settings which
were before doing default.
MTS200 settings which can be done to factory default or restore is shown in below image.
Options explained in above figure, below are explanation:
1
= to configure General settings as explained in section 9.2.1 to factory default or restore before default
settings.
2
= to configure NTP settings as explained in section 9.2.2 to factory default or restore before default
settings.
3
= to configure SNMP manager related settings as explained in section 9.2.3 to factory default or restore
before default settings.
4
= to configure Ethernet network eth0 and eth1 settings as explained in section 9.2.4 to factory default or
restore before default settings.
B
= to return to previous menu.
If user wants to change general setting to factory default, user should give “1” in command and then
press ENTER. This will lead to below figure type index which will have options for factory default or
restore. Refer below image.
