Model: MTS200 (1U)
Doc. Ref. no. : m08/om/201
Issue no. : 03
User’s Manual
Page 32 of 195
Page 32 of 195
7 Hardware Jumper Setting
FUNCTIONALITY
Hardware jumper settings inside the unit should be done while unit is in
POWER OFF condition.
This equipment is sensitive to Electrostatic Discharge (ESD). Observe all
ESD safeguards while using this equipment. Otherwise, there is danger that
the unit may get damaged through ESD.
mas
TER
T-Sync
Model MTS200 device comes with complete system configurations as per factory set
settings and if any, as per specified ordered configurations. There are few output options available that
can be changed by operator at its end i.e. Relay contacts configuration from C-NO to C-NC contacts and
COM1, COM2 terminal RS-232 to RS-485 electrical configurations. However, it is recommended to
change the hardware settings after contacting Masibus Customer Support department.
For changing above mentioned settings, jumpers are provided on the main card inside the unit. For
changing any configuration, follow below procedure step by step.
1. Power OFF the unit from supply. Remove all the output connections / cables connected on the rear
panel of
mas
TER
T-Sync
Model MTS200 unit.
2. If the unit is mounted inside the panel, please remove the unit from panel.
3. Open the top black cover of the unit by unscrewing screws on top cover. After removing the screws,
remove the top cover.
4. Change the jumpers settings as described in respective applicable section 7 as explained.
5. After changes are done, please refit the top black cover with screws.
6. After restarting the unit on Power ON, user should take care about the cable connections done on
rear panel connectors specifically about those whose output configurations have been changed
through internal jumpers.
Below Figure shows the location of Jumpers CN20, CN22, CN23 for Relay contacts, CN12, CN13 for
COM1 terminal and CN16, CN18 for COM2 terminal on the main card (front top view).
