Model: MTS200 (1U)
Doc. Ref. no. : m08/om/201
Issue no. : 03
User’s Manual
Page 182 of 195
Page 182 of 195
MTS200 can be configured with IPv6 based network settings.
Autoconf option in MTS200 can be enabled / disabled via front panel keypad menu or console based
configuration utility or SNMP or Webserver.
Once IP address and other network parameters acquired,
user can view the acquired network parameters on LCD display in respected Ethernet port menu option.
MTS200 can acquire two types of IPv6 address i.e. link-local and Global IPv6 address, if Autoconf feature
is enabled. Global IPv6 address will be acquired only if IPv6 router is available in network. Link Local
address will be acquired automatically even if Autoconf feature is disabled. Link-Local address is not
configurable.
Example:
Link local address format:
fe80::1eba:8cff:fee5:a63c
Global IPv6 address format:
fdc2:7142:77b7:0:1eba:8cff:fee5:a63c
In case of Ethernet in different subnet, both Ethernet interface will have different IPv6 address as per
isolated network in which Ethernet port is connected. In case of bonding between both Ethernet port,
global IPv6 address will be according to the current active Ethernet port.
INFORMATION
If u
nit doesn‟t found any IPv6 address it will show :: on the display as
well as on the webserver.
Any change in IPv6 address status is automatically scanned at every
minute interval till the new IPv6 address is acquired. This condition may
occur only if there is any change in Ethernet port link connection status
or on Power ON.
14 Holdover Mode
