Model: MTS200 (1U)
Doc. Ref. no. : - m08/om/201
Issue no.: 03
Page 99 of 195
User’s Manual
Option “1” will default General setting to factory default. If user wants to revert to settings which were
before default being done, user can use Option “2” to restore the settings. Option “3” will let user view the
current settings of General parameters which will be applicable.
Same method is applicable for other settings for NTP, SNMP and Ethernet. By doing default settings of
Ethernet Network, all network settings of eth0 and eth1 will go to default. Due to this other clients
connected with MTS200 Ethernet communication will break due to change in network addresses of eth0
and eth1.
Whenever user change the settings of NTP and SNMP, it is necessary for user to restart the respective
service for “Ethernet Settings” option in main menu for new changes to take effect.
9.2.7
Administration Settings Menu:
.
Option “1” in above menu is for Process list and it shows the current process running in MTS200 device.
Option “2” shows Device Version which give details about the MTS200 version information.
Option “3” “Reboot Device” option can be used to reboot the device through webserver. While this option
will cause reboot, all outputs of MTS200 will be halted till the units get started again. All log messages will
be cleared and all Ethernet services will be restarted again.
Option “4” “User Management” option can create/modify/delete system username as explained below.
