Model: MTS200 (1U)
Doc. Ref. no. : m08/om/201
Issue no. : 03
User’s Manual
Page 106 of 195
Page 106 of 195
In using
HyperTerminal
, it is recommended to select
File\Properties\Settings
and set
Emulation to
ANSI
, to avoid auto-detect making unwanted changes to the settings.
INFORMATION
Cross cable connection as mentioned in above figure is necessary to
communicate with COM2 terminal.
It is recommended to use putty instead of hyperterminal because of
limited visible screen size in hyperterminal.
Ensure serial console port communication setting done in
mas
TER
T-
Sync
Model MTS200 unit and end device should be same for proper
communication.
The port settings in
HyperTerminal
and the serial console port of unit must match each other for fruitful
communication. The factory set settings of serial console of unit are set 115200(baud rate), 8 (data bits),
N(Parity-None),2 (stop bit) and may be checked by observing the LCD on boot up.
It is necessary that user hav
e to select “NONE” option in “Hardware Flow Control” option while doing
communication parameters settings in HyperTerminal. User can check unit serial console communication
settings from Keypad Menu available on front panel of unit.
Figure 10-6 HyperTerminal Configuration
After connection is setup successfully, user will get prompt of log in menu of MTS200 unit or may be
directly to console prompt, if user have already login previously in MTS200 through serial or telnet or ssh.
Refer section 9.2 in manual for device configuration through console based utility application program.
