Model: MTS200 (1U)
Doc. Ref. no. : - m08/om/201
Issue no.: 03
Page 81 of 195
User’s Manual
Once user have entered in Ethernet menu “ETH0/1 Network Settings”, below is explanation of various
options:
1 = To check current live network settings of Eth0 and Eth1. This are network settings which are alive in
system. This mode is helpful mainly to check network settings when Ethernet port is in DHCP mode or in
Autoconf mode or when user wants to check live system IP.
2 = To view current configured Ethernet settings
3 = To configure network parameters of eth0, eth1, syslog server address and enabling/disabling network
services.
4 = This option is to restart all Ethernet services at a single option. This may be required when user have
to restart all services at one go.
5 = To view internal logged messages in /var/log/messages file.
B = to return to main menu.
To View configured network parameters of Eth0 and Eth1:
Option “2” in Ethernet main menu is used to view configured eth0, eth1 settings. In case of single
Ethernet, user can view respected single Ethernet port parameters directly. For dual Ethernet, user need
to give 1 or 2 command to view Ethernet port 0 or Ethernet port 1 parameter respectively as shown in
below figure.
To configure network parameters:
Option “3” in Ethernet main menu is used to configure eth0, eth1 parameters as shown in below image.
After pressing option “3”, user will be prompted for command value of each parameter shown in above
figure. The command number of each parameter are mentioned in left most column of parameters list.
User can do configuration of multiple values at a time by entering the command value of required
parameter. User will remain in the configuration menu till user enters
“0” in command prompt. User can
use “H” for displaying list of all parameters in middle of configuration stage.
Once all required parameters are configured, operator can save the set parameters using “0” command
and then press “y” or “Y” (yes) when prompted for saving. Whenever user is in middle of configuration
mode option and want to check the command options of other parameters of same mode, user can press
“H” for help.
