Model: MTS200 (1U)
Doc. Ref. no. : m08/om/201
Issue no. : 03
User’s Manual
Page 114 of 195
Page 114 of 195
69
P7
Position Identifier #7
70
Time Zone Offset 0.5 Hour
0 = none, 1=additional 0.5 hour time-zone offset
71
Time Quality
4-bit code representing approx. clock time error.
0000 =MTS200 Locked, maximum accuracy
1111 =MTS200 failed, data unreliable
72
Time Quality
73
Time Quality
74
Time Quality
75
Parity
Parity on All preceding data bits including time of
year
76
Not Used
Unassigned, Zero Value
77
Not Used
Unassigned, Zero Value
78
Not Used
Unassigned, Zero Value
79
P8
Position Identifier #8
Table 11-6 Assignment of CF Segment for IEEE 1344(C37.118-2005)
To use these extra bits of information, protective
Relays, RTU‟s and other equipment receiving the time
code must be able to decode them.
INFORMATION
In IEEE 1344 C37.118-2005 Leap Second, Leap Second Pending bits are not
supported in this firmware version.
11.2.2.5 Generated IRIG-B Time Codes:
mas
TER
T-Sync
model MTS200 supports different IRIG-B 00x/IRIG-B12x protocols. Supported protocols
are listed below.
a) IRIG-B007
: 100 pps, DCLS Signal, No carrier Frequency
BCDTOY, BCDYR, SBS (Time of Day)
b) IRIG-B127
: 100 pps, AM Signal, 1 KHz carrier Frequency
BCDTOY, BCDYR, SBS (Time of Day)
c) IEEE 1344 (C37.118-2005) : 100 pps, AM Signal, with 1 KHz Carrier frequency
BCDTOY, BCDYR, SBS, IEEE1344 assignment of CF bits (Refer
Section 11.2.2.4)
: 100 pps, DCLS Signal, No Carrier Frequency
BCDTOY, BCDYR, SBS, IEEE1344 assignment of CF bits (Refer
Section 11.2.2.4)
11.2.2.6 Selection/configuration of IRIG-B Time Codes:
The time code generated can be selected/configured using Telnet menu available on model MTS200
Ethernet port NTP1.
IRIG-B time code for model MTS200 can be configured for
1) IEEE 1344 C37.118
– 2005 protocol enabling
2) UTC time on IRIG-B time code or Local time on IRIG-B time code.
IRIG-B DCLS time codes (IRIG-B 00x) and IRIG-B AM time codes (IRIG-B 12x) are always generated
simultaneously. Using telnet if we configure the IRIG-B output for IEEE 1344 protocol than both IRIG-
B00x and IRIG-B12x gives IEEE 1344 protocol CF bits output. Similarly, we can configure IRIG-B output
