Model: MTS200 (1U)
Doc. Ref. no. : m08/om/201
Issue no. : 03
User’s Manual
Page 172 of 195
Page 172 of 195
Figure 13-6 MTS200 Webserver Network Status Page
User can configure syslog server1 and syslog server2 IP address in their respective filed. For further
explanation, refer section 13.5.
Once user modify the requir
ed data, click on “Save” options provided at end of page. This will save the
changed parameters in MTS200
. Other options provided at end of page include “Default Configurations”
used to default the settings of GENERAL parameters, “Restore Configurations” which is used to restore
previous saved settings if user have defaulted all parameters and “View Configurations” to view the
current GENERAL parameters values. User need to click on “Save” option after doing “Default
Configurations” or “Restore Configurations” or change on any parameter.
Apart from setting network parameters, network services such as Telnet, SSH, HTTP, HTTPS, SNMP can
be enabled or disabled in “Network Services” field. Once configuration done, select “Save Status” to save
the network services status.
Note:
1. MTS200 will automatically reboot if there is change in any parameter related to ETH0, ETH1 and
bonding.
2. If MTS200 is provided with only single Ethernet option, the other Ethernet port related
parameters/configurations will be disabled and not accessible by operator.
3. Use of static instead of dynamic IP for both ETHx connectors as dynamic IP may change on every
Power reboot of device or on making eth0 service disable/enable.
4. User cannot stop HTTP and HTTPS service when configuring through webserver. At a time, HTTP or
HTTPS service will be active to avoid complete disabling of webserver service.
“NTP” Webpage:
For MTS200 NTP settings and internal ntp driver satus
, user need to navigate and select the “NTP ->
NTP Configurations
” for ntp configurations and “NTP->NTP Status” for ntp driver status in menu index.
