Model: MTS200 (1U)
Doc. Ref. no. : - m08/om/201
Issue no.: 03
Page 63 of 195
User’s Manual
This parameter instructs the GPS receiver to output the 1PPS output pulse earlier in time to compensate
for antenna cable delay. Up to 100 microseconds of equivalent cable delay can be removed. Zero cable
delay is set for a zero-length antenna cable.
The user should consult a cable data book for the delay per unit length for the particular antenna cable
used in order to compute the total cable delay needed for a particular installation.
This parameter may also be employed by the user to adjust the position of the 1PPS to compensate for
other system delays.
Range: 0to 99999 ns
Default value: 0 ns
Resolution: 1 ns
To modify value of SPD, follow below steps:
1. Go to SPD menu using UP/DOWN arrow keys.
2. Press OK key.
3. You can see blinking cursor on last digit.
4. Change the value of specific digit using UP/DOWN arrow keys and change the position of
blinking cursor using LEFT/RIGHT arrow keys.
5. Press OK key.
6. Wait till "Configuring....." message is there on display.
FUNCTIONALITY
This change in the value of this parameter will bring shift in 1PPS and
other output signal timing.
RESET UNIT :
This mode will do software reboot of MTS200 device. For that just go to RESET UNIT menu using
UP/DOWN arrow keys. After reaching at that menu, only press OK key.
Device will be restart. Wait till time and date are there on Display.
DEFAULT SETTINGS :
Here, user can configure all factory default settings individually for GENERAL, ETHERNET, NTP and
SNMP SETTINGS. For that just follow below steps:
1. Go to DEFAULT SETTINGS menu using UP/DOWN arrow keys as shown in figure.
