MARUTI SUZUKI BALENO 2017, Owner'S Manual

Page: 273 / 324

7-17
INSPECTION AND MAINTENANCE
68PH0-74E
NOTE:
Do not check the fluid level if you have just
driven the vehicle for a long time at high
speed, or if you have driven in city traffic in
hot weather. Wait until the fluid cools down
(about 30 minutes), or the fluid level indi-
cation will not be correct.
3) Park your vehicle on level ground.
4) Apply the parking brake and then start
the engine in “P” (Park). Let it idle for
two minutes and keep it running during
the fluid level check.
5) With your foot on the brake pedal,
move the gearshift lever through each
gear, pausing for about three seconds
in each range. Then move it back to the
“P” (Park) position.
68PH00714
68PH00715
68PH00716
(1) FULL
(2) LOW
(3) The lowest point = Fluid level
6) The handle of the CVT fluid dipstick is
colored red for easy identification.
Remove the dipstick, clean it and push
it back in until the cap seats. Then pull
out the dipstick.
7) Check both sides of the dipstick, and
read the lowest level. The fluid level
should be between the two marks in the
“HOT” range on the dipstick.
Deterioration Checking or Chang-
ing Oil
Since special procedures, materials and
tools are required to check the deteriora-
tion of CVT oil or change, it is recom-
mended that you trust this job to your
authorised Maruti Suzuki workshop.
WARNING
Be sure to depress the brake pedal
when moving the gearshift lever, or
the vehicle can move suddenly.
EXAMPLE
EXAMPLE
(1)
(2)
(3)
EXAMPLE
NOTICE
After checking or adding oil, be sure
to insert the dipstick securely.