MARUTI SUZUKI BALENO 2017, Owner'S Manual

Page: 99 / 324

2-81
BEFORE DRIVING
68PH0-74E
Driving time
68PM00286
(10) Driving time
Driving time from previous reset is shown.
To reset the driving time, push and hold the
indicator selector knob (2) for about 2 sec-
onds when the display indicates a driving
time. The display shows “---” and then indi-
cates a new driving time after driving for a
short time.
NOTE:
Disconnection of the battery negative (-)
terminal will reset the indication of the driv-
ing time.
Clock and date
Date and time are shown. For the setting
procedure, refer to “Setting mode” in this
section.
Torque and Power
Present engine torque and power are
shown.
Information of after driving
When you press the engine switch to
change the ignition mode to “LOCK”
(OFF), the following information appears
for several seconds on the information dis-
play.
68PS00214
Trip Summary display
Trip Summary display comes when ignition
mode is switched to ‘OFF” position. Fol-
lowing summary is displayed.
• Driving Time : Time from ignition “ON”
condition to ignition “OFF” condition is
displayed.
• Driving Mileage : Distance covered from
ignition “OFF” condition is displayed.
Torque and Power display
Display (e) shows Torque and Power
graphs at various vehicle condition.
This figure is for reference only and indica-
tion may not be same as actual value.
Gearshift Indicator / Gear Position
Indicator (if equipped)
The display (D) shows some of the follow-
ing indications.
Gearshift indicator
Refer to “Gearshift Indicator” in the
“OPERATING YOUR VEHICLE” section.
Gear position indicator
68PM02002
When the engine is in running condition
and the gearshift lever position is other
than neutral, the display (D) indicates the
current gear position (1).
For details on how to use the transaxle,
refer to “Using the Transaxle” in the
“OPERATING YOUR VEHICLE” section.
(10) (10)
EXAMPLE
EXAMPLE
(1)
EXAMPLE