MacDon D1 Series, Unloading And Assembly Instructions, Page: 210 / 546

215184
186
Revision A
1026173
B
A
C
C
Figure 6.24: Wide Configuration
–
Right Side
6. Converting from Wide configuration: Remove bolts (A),
access cover (B), and two flighting slot plugs (C) from the
right side of the auger.
7. Repeat Steps 2, page 185 to 6, page 186 at the left side of
the feed auger.
1026219
A
C
B
Figure 6.25: Narrow Configuration
–
Right Side
8. Install two bolt-on flightings (A) on the right side as shown,
and secure each flighting with six carriage head bolts
(MD #136178) and nuts (MD #135799) at locations (B).
IMPORTANT:
Bolt heads must be installed on the inside of the auger to
prevent damaging internal components.
9. Torque all nuts and bolts to 47 Nm (35 lbf·ft) to eliminate
deflection on flighting, then torque them to 58
–
64 Nm
(43
–
47 lbf·ft).
10. Install flighting slot plug (MD #213084) at location (C) from
inside the auger and secure with an M6 hex head bolt
(MD #252703) and tee nut (MD #197263). Repeat for the
other flighting mounting locations.
1026221
A
C
B
Figure 6.26: Narrow Configuration
–
Left Side
11. Install two bolt-on flightings (A) on the left side as shown,
and secure each flighting with six carriage head bolts
(MD #136178) and nuts (MD #135799) at locations (B).
IMPORTANT:
Bolt heads must be installed on the inside of the auger to
prevent damaging internal components.
12. Torque all nuts and bolts to 47 Nm (35 lbf·ft) to eliminate
deflection on flighting, then torque them to 58
–
64 Nm
(43
–
47 lbf·ft).
13. Install flighting slot plug (C) (MD #213084) from inside the
auger and secure with an M6 hex head bolt (MD #252703)
and tee nut (MD #197263). Repeat for the other
flighting mounting location used to mount the previous
flighting in Step
3, page 185 .
14. Remove extra auger fingers. A total of 18 fingers is recommended for this configuration. For instructions, refer to
6.2.11 Removing Feed Auger Fingers, page 200 .
FLOAT MODULE SETUP AT DEALER