215184
141
Revision A
1009653
B
C
A
D
Figure 3.301: Pointed Guard
1009655
A
B
C
D
Figure 3.302: Stub Guard
2.
Place hold-down clip (A) on cutterbar as shown and secure
with existing nuts (B). Adjuster bolt (C) should
NOT
require adjusting.
NOTE:
Cutterbar wearplates should be installed with special
bolts (D) as shown.
3.
Repeat the previous steps for the second (adjacent)
location.
4.
Torque nuts (B) to 88 Nm (65 lbf
∙
ft).
5.
Check and adjust the clearance between the
hold-down clips and the knife. For instructions, refer to
Checking Knife Hold-Downs, page 266
.
If the header is to be assembled at one location and then transported to a MacDon dealership, proceed to
Header for Transport to Dealership, page 143
.
If the header is being assembled at the MacDon dealership, proceed to