215184
280
Revision A
1001329
A
B
Figure 8.36: Outside Reel Arm
4.
Adjust the outboard reel arm lift cylinders to set the
clearance at the outboard ends of the reel as follows:
a.
Loosen bolt (A).
b.
Turn cylinder rod (B) out of clevis to raise reel and
increase clearance to cutterbar, or turn cylinder rod
into clevis to lower reel and decrease clearance.
c.
Tighten bolt (A).
d.
Repeat at opposite side.
1009601
A
B
C
Figure 8.37: Underside of Center Arm
5.
For double reel:
Adjust center arm lift cylinder stop (A) to
change clearance at inboard ends of reels as follows:
a.
Loosen nut (B).
NOTE:
To make adjustment easier, lower reel onto the safety
props after loosening nut (B).
b.
Turn nut (C) counterclockwise to raise reel and increase
clearance to cutterbar, or clockwise to lower reel and
decrease clearance.
c.
Tighten nut (B).
6.
Check measurements and, if necessary, repeat adjustment procedures.
7.
Move the reel back to ensure the steel end fingers do
NOT
contact the deflector shields.
8.
If contact occurs, adjust the reel upward to maintain the clearance at all reel fore-aft positions. If contact cannot be
avoided after adjusting the reel, trim the steel end fingers to obtain proper clearance.
9.
Periodically check for evidence of contact during operation, and adjust clearance as required.
10. Shut down the engine, and remove the key from the ignition.
