215184
332
Revision A
1010069
A
Figure 9.55: Control Handle
–
Case IH 5088/6088/7088
Setting the Sensitivity of the Auto Header Height
–
Case IH 5088/6088/7088
The sensitivity adjustment controls the distance the cutterbar must travel up or down before the auto header height
control (AHHC) reacts and raises or lowers the feeder house. When the sensitivity is set to maximum, only small changes in
ground height are needed to cause the feeder house to raise or lower. When the sensitivity is set to minimum, large
changes in the ground height are needed to cause the feeder house to raise or lower.
NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to the combine
operator
’
s manual for updates.
1027737
D
B
C
A
Figure 9.56: Combine Controls
1.
Use HEADER SETTINGS key (A) to display the HEADER
SENSITIVITY CHANGE page as shown in Figure
2.
Use the UP key (B) or DOWN key (C) to adjust the
highlighted item. The height sensitivity setting range is 0
(least sensitive) to 250 (most sensitive) in increments of 10.
NOTE:
Adjustments take effect immediately. Use the CANCEL key
to return to the original settings.
3.
Use HEADER SETTINGS key (A) to highlight the next
changeable item.
4.
Use ENTER key (D) to save changes and return to the
monitor screen. If there are no changes, the screen will
return to the monitor screen after 5 seconds.