215184
57
Revision A
1008428
A
D
E
B
C
Figure 3.92: Knifehead
5.
Remove the protective covering from knifehead (A) and
slide the knife into place. Align knifehead with pitman
arm (B).
6.
Tap knifehead pin (C) down into the knifehead (A), ensuring
pin is bottomed out in the knifehead.
7.
Tap the underside of knifehead (A) until the pin is flush
with upper face (D) of pitman arm and it just contacts
pitman arm with a gap (E) of 0.25 mm (0.010 in.).
1008432
A
B
Figure 3.93: Knifehead
8.
Reinstall bolt and nut (A).
9.
Tighten nut to 220 Nm (160 lbf·ft).
10. Reinstall grease fitting (B) in pin.
11. Grease the bearing.
NOTE:
To prevent binding and/or excessive wear caused by knife
pressing on guards, do
NOT
overgrease. If more than 6 to 8
pumps of the grease gun are required to fill the cavity,
replace the seal in the knifehead.
3.2.9
Moving Reel Arm
1008985
A
B
Figure 3.94: Extension with Reel Arm
1.
Attach reel arm to a forklift (or equivalent) with slings.
Position slings to prevent shifting when the last bolt is
removed.
2.
Remove hardware (A) securing the forward end of the reel
arm to shipping support (B).