215184
482
Revision A
Setting Preset Cutting Height
–
New Holland CR Series
NOTE:
This section applies only to 2015 and later CR models (6.80, 6.90, 7.90, 8.90, 9.90, and 10.90). For other pre-2015 New
Holland combine models, refer to
1015008
A
B
C
Figure 9.393: New Holland Combine Controls
The console has two buttons used for auto height presets. The
toggle switch that was present on previous models is now
configured as shown at right. MacDon headers only require first
two buttons (A) and (B). Third button (C) is not configured.
WARNING
Check to be sure all bystanders have cleared the area.
To set preset cutting height, follow these steps:
1024394
A
Figure 9.394: New Holland Combine Controls
1.
Engage separator and header.
2.
Select preset button 1 (A). A yellow light on the button will
illuminate.
3.
Raise or lower the header to the desired cutting height.
1024067
C
Figure 9.395: New Holland Combine
Multifunction Handle
4.
Hold RESUME button (C) on the multifunction handle to set
the preset.
NOTE:
When setting presets, always set header position before
setting reel position. If header and reel are set at the same
time, the reel setting will not save.
5.
Raise or lower the reel to the desired working position.
6.
Hold RESUME button (C) on multifunction handle to set the
preset.
7.
Repeat Step
to Step
, using preset
button 2.
