215184
467
Revision A
1003606
1003606
Figure 9.361: New Holland Combine Display
3.
Follow the calibration steps in the order in which they
appear in the dialog box. As you proceed through the
calibration process, the display will automatically update to
show the next step.
NOTE:
Pressing the ESC key during any of the steps or letting the
system sit idle for more than 3 minutes will cause the
calibration procedure to stop.
NOTE:
Refer to your combine operator
’
s manual for an
explanation of any error codes.
4.
When all steps have been completed, CALIBRATION SUCCESSFUL message is displayed on the screen. Exit the
CALIBRATION menu by pressing the ENTER or ESC key.
NOTE:
If float was set heavier to complete AHHC calibration procedure, adjust to recommended operating float after the
calibration is complete.
5.
If the unit does not function properly, conduct the maximum stubble height calibration.
Calibrating Maximum Stubble Height
–
New Holland CR/CX Series
This procedure describes how to calibrate the area counter to stop or start counting at the correct height. Program the
header to a height that will never be reached while cutting. The area counter will stop counting when the header is above
the programmed height, and will begin counting when the header is below the programmed height.
Select the height of the header that corresponds to the description above.
IMPORTANT:
•
If the value is set too low, area may
NOT
be counted since the header is sometimes raised above this threshold
although the combine is still cutting.
•
If the value is set too high, the area counter will keep counting even when the header is raised (but below this
threshold) and the combine is no longer cutting crop.
WARNING
Check to be sure all bystanders have cleared the area.