215184
348
Revision A
NOTE:
If header float is set too light, it can prevent calibration of AHHC. You may need to set the float heavier for calibration
procedure so header doesn
’
t separate from the float module.
1.
Ensure center-link is set to
D
.
2.
Ensure all header and float module electrical and hydraulic connections are made.
1025386
A
Figure 9.94: Case IH Combine Display
3.
Select TOOLBOX (A) on the MAIN page.
1025903
A
B
C
C
Figure 9.95: Case IH Combine Display
4.
Select HEADER tab (A).
NOTE:
To locate the HEADER tab, you may need to scroll to the
right using side arrows (C).
5.
Set appropriate HEADER STYLE (B).
1003938
Figure 9.96: Case IH Combine Display
6.
Set AUTO REEL SPEED SLOPE.
NOTE:
The AUTO REEL SPEED SLOPE value is the percentage of the
reel speed compared to the ground speed. For example, if
the value is set to 100, then the reel speed will be the same
as the ground speed. Normally you want the reel going
slightly faster than the ground speed. However, adjust the
value according to crop conditions.
7.
Set HEADER PRESSURE FLOAT to NO if equipped, and
ensure REEL DRIVE is HYDRAULIC.