215184
439
Revision A
Adjusting the Manual Header Raise/Lower Rate
–
John Deere S and T Series
NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to the combine
operator
’
s manual for updates.
1023870
A
B
C
D
Figure 9.292: Float Indicator Box
NOTE:
Indicator (A) should be at position 0 (B) with the header 152 mm
(6 in.) off the ground. If not, the float sensor output voltage
should be checked; refer to Step
. When the header
is on the ground, the indicator should be at position 1 (C) for low
ground pressure, and at position 4 (D) for high ground pressure.
Crop and soil conditions determine the amount of float to use.
The ideal setting is as light as possible without header bouncing
or missing crop. Operating with heavy settings prematurely
wears the cutterbar wearplates.
1003757
A
Figure 9.293: John Deere Combine Command Center
1.
Press button (A) and the current sensitivity setting will
appear on the monitor.
1003759
A
Figure 9.294: John Deere Combine Display
2.
Press
–
or
+
icons (A) to adjust rates.
NOTE:
The numbers shown on the combine display in this
illustration are for reference purposes only; they are not
intended to represent the specific settings for your
equipment.