215184
383
Revision A
1026242
A
B
Figure 9.176: CLAAS Combine Display and Console
1.
Use HOTKEY rotary dial (A) to select REEL icon (B).
1026244
A
B
C
Figure 9.177: CLAAS Combine Display and Console
2.
Use control knob (A) to select AUTO REEL HEIGHT icon (B)
at the top of the page.
NOTE:
AUTO REEL HEIGHT icon (C) at the center of the page
should be highlighted black. If it is not black, either the end
stops have not been set or the AHHC is not active. For
instructions, refer to
Calibrating Reel Height Sensor
.
1026245
A
B
Figure 9.178: CLAAS Combine Display and Console
3.
Adjust the auto reel height position for the current AHHC
position using outer scroll knob (A). To lower the preset
reel position, turn the scroll knob counterclockwise; to raise
the preset reel position, turn the scroll knob clockwise. The
display will update current setting (B).
NOTE:
If the AUTO REEL HEIGHT icon in the center of the page is
not black, an AHHC position is not currently active.
9.1.11
CLAAS 8000/7000 Series Combines
Setting up the Header
–
CLAAS 8000/7000 Series
Follow these steps to setup a MacDon header:
