215184
283
Revision A
1026233
A
B
C
Figure 8.41: Auger Clearance
5.
Loosen two nuts (B) and rotate the auger to position the
flighting over the feed pan.
6.
Turn bolt (A) clockwise to increase clearance (C); turn
bolt (A) counterclockwise to decrease clearance (C).
•
If the feed auger is in the fixed position, set clearance to
22
–
26 mm (7/8
–
1.0 in.).
•
If the feed auger is in the floating position, set clearance
to 11
–
15 mm (7/16
–
5/8 in.).
NOTE:
The clearance increases between 25
–
40 mm (1
–
1 1/2 in.)
when the center-link is fully retracted.
7.
Repeat Steps
and
for the opposite
end of the auger.
IMPORTANT:
Adjusting one side of the auger can affect the other side.
Always double-check both sides of the auger after making
final adjustments.
8.
Tighten nuts (B) on both ends of the feed auger. Torque the
nuts to 93
–
99 Nm (68
–
73 lbf·ft).
9.
Rotate the drum and double-check clearances.