MacDon D1 Series, Unloading And Assembly Instructions, Page: 16 / 546

Section Summary of Change Internal Use
Only
•
Step 6, page 471
10 Checking and Adjusting Reel
Height Sensor, page 487 Replaced the WARNING with the following DANGER:
•
To avoid bodily injury or death from unexpected start-up or
fall of a raised machine, always stop engine and remove key
before leaving the operator
’
s seat, and always engage safety
props before going under the machine for any reason.
Tech Pubs
10 Checking and Adjusting Reel
Height Sensor, page 487
•
Figure 10.1, page 487
Added AGCO IDEAL
™
to picture legend.
ECN 58283
10 Checking and Adjusting Reel
Height Sensor, page 487
•
See NOTE below Figure 10.1,
page 487
Reworded the NOTE as follows:
•
For configuration (A), pointer (D) points to the FRONT of the
header.
•
For configuration (B), pointer (D) points to the REAR of the
header.
Tech Pubs
10 Checking and Adjusting Reel
Height Sensor, page 487
•
Step 1, page 487
Added safety step:
•
Shut down the engine, and remove the key from the ignition.
Tech Pubs
10 Checking and Adjusting Reel
Height Sensor, page 487
•
Table 10.1, page 488
Added AGCO IDEAL
™
to table.
ECN 58283
10 Checking and Adjusting Reel
Height Sensor, page 487
•
Step 10, page 489
Added safety step:
•
Engage the reel safety props.
Tech Pubs
10 Checking and Adjusting Reel
Height Sensor, page 487
•
Step 17, page 489
Added safety step:
•
Disengage the reel safety props.
Tech Pubs
11 Running up Header, page 491 Removed the following redundant step:
•
Lower plastic pan under float module and check for shipping
materials/debris that may have fallen under float module
draper.
Tech Pubs
215184
xiv
Revision A