215184
192
Revision A
6.2.7
Converting from Wide Configuration to Ultra Wide Configuration
1.
Improve access and ease installation by removing the float module from the combine. For instructions, refer to the
header operator
’
s manual or technical manual.
1026207
A
D
B
C
Figure 6.39: Wide Configuration
–
Right Side
2.
Remove two bolts and access cover (A).
3.
Remove hardware (B) and bolt-on flighting (C).
4.
Install flighting slot plugs (MD #213084) in the flighting
mounting locations (D) and secure with M6 bolts
(MD #252703) and tee nuts (MD #197263).
5.
Repeat all steps on the left side of the auger.
6.
Install additional auger fingers. A total of 30 fingers are
recommended for this configuration. For instructions, refer
to
6.2.10 Installing Feed Auger Fingers, page 198
6.2.8
Converting from Medium Configuration or Wide Configuration to Ultra Narrow
Configuration
Four flighting kits (MD #287032 or B6400
2
) and some hole-drilling are required to convert to Ultra Narrow configuration.
Extra hardware is included in these kits. Be sure to use the correct hardware in the correct location to prevent damage and
to maximize performance.
1.
Improve access and ease installation by removing the float module from the combine. For instructions, refer to the
header operator
’
s manual or technical manual.
1026172
B
A
C
D
E
Figure 6.40: Wide Configuration
–
Right Side
2.
Remove bolts (A) and access cover (B) from the right side of
the auger. Retain for reassembly.
3.
Remove hardware (C) and bolt-on flighting (D) from
the auger.
4.
Remove flighting slot plug (E) located close to the end of
flighting (D).
5.
Converting from Medium configuration:
Repeat the
previous steps for the other bolt-on flighting on the
same side.
2.
MD #287032 is available only through MacDon Parts. B6400 is available only through Whole Goods.