215184
366
Revision A
9.1.9
CLAAS 500 Series Combines
Calibrating the Auto Header Height Control
–
CLAAS 500 Series
For best performance of the auto header height control (AHHC), perform these procedures with the center-link set to
D
.
When setup and calibration are complete, adjust the center-link back to desired header angle. For instructions, refer to
Header Angle in the header operator
’
s manual for instructions.
NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to the combine
operator
’
s manual for updates.
NOTE:
If header float is set too light, it can prevent calibration of AHHC. You may need to set the float heavier for calibration
procedure so header doesn
’
t separate from the float module.
1.
Ensure center-link is set to
D
.
1010067
A
B
C
Figure 9.136: CLAAS Combine Controls
2.
Use < key (A) or > key (B) to select AUTO HEADER, and
press OK key (C). The E5 screen displays whether the
automatic header height is on or off.
1003749
A
B
C
Figure 9.137: CLAAS Combine Controls
3.
Use
–
key (A) or
+
key (B) to turn the AHHC on, and press
OK key (C).
4.
Engage the threshing mechanism and the header.
