215184
362
Revision A
1018167
A
Figure 9.127: Challenger Combine Display
4.
Press HEADER button (A). The HEADER CALIBRATION screen
displays a warning.
1003669
Figure 9.128: Challenger Combine Display
5.
Read the warning message, and then press the green check
mark button.
1003670
Figure 9.129: Challenger Combine Display
6.
Follow the on-screen prompts to complete calibration.
NOTE:
The calibration procedure can be canceled at any time by
pressing the cancel button in the bottom right corner of the
screen. While the header calibration is running, the
calibration can also be canceled by using the UP, DOWN,
TILT RIGHT, or TILT LEFT buttons on the control handle.
NOTE:
If the combine does not have HEADER TILT installed or if it
is inoperable, you may receive warnings during calibration.
Press the green check mark if these warnings appear. This
will not affect the AHHC calibration.
NOTE:
If the float was set heavier to complete the AHHC
calibration procedure, adjust to the recommended
operating float after the calibration is complete.