215184
185
Revision A
6.2.3
Converting from Medium Configuration or Wide Configuration to Narrow
Configuration
Two flighting kits (MD #287032 or B6400
1
) are required to convert to this configuration. Extra hardware is included in these
kits. Be sure to use the correct hardware in the correct location to prevent damage and to maximize performance.
1017317
1
2
A
A
A
A
3
B
B
Figure 6.22: Auger Configurations
–
Rear View
1 - Medium Configuration
2 - Wide Configuration
3 - Narrow Configuration
Medium, Wide, and Narrow auger configurations are shown at
right. When converting from Medium or Wide configuration to
Narrow configuration, you will need to replace existing
flightings (A) with flightings (B).
NOTE:
Flighting performs best when no gaps are present. If desired, use
silicone sealant to fill the gaps.
NOTE:
All illustrations show the feed auger separated from the float
module for clarity. The procedure can be performed with the
feed auger installed in the float module.
1.
To improve access and ease installation, remove float module from combine. For instructions, refer to the header
operator
’
s manual or technical manual.
1026172
B
A
C
D
E
Figure 6.23: Wide Configuration
–
Right Side
2.
Remove bolts (A) and access cover (B) from the right side of
the auger. Retain for reassembly.
3.
Remove hardware (C) and bolt-on flighting (D) from
the auger.
4.
Remove and discard flighting slot plug (E) located close to
the end of flighting (D).
5.
Converting from Medium configuration:
Repeat above
steps for the other flighting on the right side.
1.
MD #287032 is available only through MacDon Parts. B6400 is available only through Whole Goods. Both kits contain
wear-resistant flightings.