Juniper JUNOSE 11.0.X MULTICAST ROUTING, Configuration Manual

Page: 454 / 788

■
Reset a dial-out session by forcing it to the dormant state.
host1# l2tp dial-out session reset 10.10.0.0
l2tp dial-out connecting-timer-value
■
Use to set the maximum time allowed for attempts to establish L2TP dial-out
sessions.
■
If the session fails to be established before the connecting timer expires,
subsequent attempts to establish the dial-out session to the same destination
are inhibited temporarily.
■
The range is 30–3600 seconds.
■
Example
host1(config)# l2tp dial-out connecting-timer-value 30
■
Use the no version to set the connecting timer to the default, 30 seconds.
■
See l2tp dial-out connecting-timer-value
l2tp dial-out dormant-timer-value
■
Use to set how long the dial-out session waits in the dormant state for a new
trigger after the associated L2TP outgoing call ends.
■
If no trigger is received before the dormant timer expires, the dial-out session
is deleted.
■
The range is 0–3600 seconds.
■
Example
host1(config)# l2tp dial-out dormant-timer-value 300
■
Use the no version to set the dormant timer to the default, 300 seconds (5
minutes).
■
See l2tp dial-out dormant-timer-value
l2tp dial-out max-buffered-triggers
■
Use to set the maximum number of buffered trigger packets held for any dial-out
session pending the successful establishment of the L2TP session. Once the
session is established, the buffered trigger packets are transmitted.
■
Trigger packets received when the maximum number of triggers are already
buffered are discarded.
■
The range of values is 0–50.
■
Example
host1(config)# l2tp dial-out max-buffered-triggers 50
■
Use the no version to set the number of trigger buffers to the default, 0.
■
See l2tp dial-out max-buffered-triggers
414 ■
Configuring L2TP Dial-Out
JUNOSe 11.0.x Broadband Access Configuration Guide