Juniper JUNOSE 11.0.X MULTICAST ROUTING, Configuration Manual

Page: 669 / 788

Chapter 26
Monitoring Subscriber Interfaces
This chapter describes how to monitor static and dynamic subscriber interfaces for
remote access to the E Series router. This chapter contains the following sections:
■
Monitoring Subscriber Interfaces Overview on page 629
■
Monitoring Subscriber Interfaces on page 629
■
Monitoring Active IP Subscribers Created by Subscriber Management on page 630
Monitoring Subscriber Interfaces Overview
Purpose
The state of the subscriber interface is determined by state of the Ethernet interface
and the existence of the primary IP interface, which you can monitor with the show
ip interface command. For information about using the
show ip interface command,
see the Monitoring IP section in JUNOSe IP Services Configuration Guide .
Action
You can use the show ip demux interface command to monitor the configuration
of subscriber interfaces.
Monitoring Subscriber Interfaces
Purpose
Display information about subscriber interfaces.
Action
To display subscriber interface information:
host1# show ip demux interface fastEthernet 2/0
Prefix/Length SA/DA Subscriber-Intf VR/VRF Description
10.12.2.2/32 SA ip subsc1 3 subsc1@test
10.12.2.3/32 SA ip subsc2 3 subsc2@test
10.12.2.4/32 SA ip subsc3 3 subsc3@test
10.12.2.5/32 SA ip subsc4 3 subsc4@test
Meaning
Table 136 on page 629 lists the show ip demux interface command output fields.
Table 136: show ip demux interface Output Fields
Field Description Field Name
Source or destination addresses that the subscriber interface demultiplexes Prefix/Length
Monitoring Subscriber Interfaces Overview
■ 629