Juniper JUNOSE 11.0.X MULTICAST ROUTING, Configuration Manual

Page: 269 / 788

■
See radius include
■
Example
host1(config)# radius include ipv6-accounting acct-stop enable
■
Use the no version to restore the default, disable.
ANCP-Related Juniper Networks VSAs
You use the radius include command to specify information about Access Node
Control Protocol (ANCP), also known as Layer 2 Control (L2C), that you want to
include in the RADIUS Access-Request, Acct-Start, and Acct-Stop messages. Also, if
you specify Acct-Stop messages, the router includes ANCP information in Interim-Acct
messages that the router sends to RADIUS. By default, the router does not include
the ANCP-related information provided by the Juniper Networks VSAs in RADIUS
messages.
These Juniper Networks ANCP-related VSAs are based on definitions in GSMP
extensions for layer2 control (L2C) Topology Discovery and Line
Configuration—draft-wadhwa-gsmp-l2control-configuration-00.txt (July 2006
expiration).
radius include l2cd-keyword
■
Use to include ANCP-related Juniper Networks VSAs in Access-Request, Acct-Start,
and Acct-Stop messages that the router sends to RADIUS. If you enable inclusion
of the ANCP-related VSAs in Acct-Stop messages, the router also includes the
VSAs in Interim-Acct messages. Inclusion is disabled by default.
■
You must enable ANCP discovery with the discovery-mode command prior to
configuring the radius include command with the ANCP-related VSAs. Configuring
discovery mode enables the RADIUS authentication server to retrieve ANCP
information.
■
Table 44 on page 229 lists the ANCP (L2C)-related keywords that you can use in
the
radius include command and the associated Juniper Networks VSAs. The
table also indicates the mappings between ANCP parameters and the VSAs.
Table 44: ANCP (L2C)-Related Keywords for radius include Command
ANCP
Subtype ANCP
Type Juniper Networks
VSA Name Juniper Networks
VSA Number
Command Keyword
– 1 Acc-Loop-Cir-Id [26-110] l2cd-acc-loop-cir-id
– 2 Acc-Aggr-Cir-Id-Bin [26-111] l2cd-acc-aggr-cir-id-bin
– 3 Acc-Aggr-Cir-Id-Asc [26-112] l2cd-acc-aggr-cir-id-asc
129 4 Act-Data-Rate-Up [26-113] l2cd-act-data-rate-up
130 4 Act-Data-Rate-Dn [26-114] l2cd-act-data-rate-dn
CLI Commands Used to Modify RADIUS Attributes
■ 229
Chapter 3: Configuring RADIUS Attributes