Juniper JUNOSE 11.0.X MULTICAST ROUTING, Configuration Manual

Page: 259 / 788

Use to include the Tunnel-Interface-Id attribute in Access-Request, Acct-Start, or
Acct-Stop messages.
■
■
You can control inclusion of the attribute by enabling or disabling this command.
■
See radius include
■
Example
host1(config)# radius include tunnel-interface-id enable
■
Use the no version to restore the default, disable.
[26-45] Ipv6-Virtual-Router
Use the following command to manage the IPv6-Virtual-Router RADIUS attribute.
■
radius include ipv6-virtual-router
radius include ipv6-virtual-router
■
Use to include the Ipv6-Virtual-Router attribute in Acct-Start, or Acct-Stop
messages.
■
You can control inclusion of the attribute by enabling or disabling this command.
■
For this attribute, the value received from the RADIUS server in the Access-Accept
message is used in the accounting messages.
■
If the IPv6 virtual router is configured in the AAA domain map and is not returned
from the RADIUS server, the Acct-Start, Acct-Stop, or Interim-Acct messages
report the value configured in the domain map.
■
If IPv6 virtual router is not configured in the AAA domain map and is not returned
from the RADIUS server, it is not included in the Acct-Start message because the
value is not yet known. If the IPv6 virtual router context is configured from the
profile, it is reported in the immediate-update message for DHCPv6 prefix
delegation.
■
See radius include
■
Example
host1(config)# radius include ipv6-virtual-router acct-start enable
■
Use the no version to restore the default, disable.
[26-46] Ipv6-Local-Interface
Use the following command to manage the Ipv6-Local-Interface RADIUS attribute.
■
radius include ipv6-local-interface
radius include ipv6-local-interface
CLI Commands Used to Modify RADIUS Attributes
■ 219
Chapter 3: Configuring RADIUS Attributes