Juniper JUNOSE 11.0.X MULTICAST ROUTING, Configuration Manual

Page: 297 / 788

Table 49: RADIUS IETF Attributes Supported by JUNOSe Software (continued)
Description Attribute Name
Attribute
Number
■
Indicates how many times the Acct-Output-Octets counter has wrapped around
2^32 in the course of delivering this service, and can be present in
Accounting-Request records only where the Acct-Status-Type is set to Stop or
Interim-Update
■
IP subscriber manager—Statistics are reported
■
PPP—Statistics are counted according to the rules of the generic interface
MIB
Acct-Output-Gigawords [53]
Records the time that this event occurred on the NAS, in seconds, since January
1, 1970 00:00 UTC Event-Timestamp [55]
Contains the CHAP challenge sent by the NAS to a PPP CHAP user CHAP-Challenge [60]
■
Indicates the type of physical port the NAS is using to authenticate the user
■
See the radius dsl-port-type and the radius ethernet-port-type commands
in “Configuring RADIUS Attributes” on page 165.
NAS-Port-Type [61]
Specifies the maximum number of MLPPP member links allowed for the subscriber Port-Limit [62]
■
Which tunneling protocol to use (in the case of a tunnel initiator) or the
tunneling protocol in use (in the case of a tunnel terminator)
■
Only L2TP tunnels supported at this time
Tunnel-Type [64]
■
Transport medium to use when creating a tunnel for those protocols (such as
L2TP) that can operate over multiple transports
■
Only IPv4 supported at this time
Tunnel-Medium-Type [65]
Address of the initiator end of the tunnel Tunnel-Client-Endpoint [66]
Address of the server end of the tunnel Tunnel-Server-Endpoint [67]
■
Indicates the identifier assigned to the tunnel session
■
Value is L2TP call-serial number
Acct-Tunnel-Connection [68]
Password to be used to authenticate to a remote server Tunnel-Password [69]
Sent from the NAS to indicate the nature of the user’s connection Connect-Info [77]
Encapsulates EAP packets, which allows the NAS to authenticate users through
EAP without having to understand the EAP protocol EAP-Message [79]
Must be used in any Access-Request, Access-Accept, Access-Reject or Access-
Challenge messages that include EAP-Message attributes Message-Authenticator [80]
Indicates to the tunnel initiator the particular tunnel to which a session is to be
assigned Tunnel-Assignment-Id [82]
RADIUS IETF Attributes
■ 257
Chapter 6: RADIUS Attribute Descriptions