Juniper JUNOSE 11.0.X MULTICAST ROUTING, Configuration Manual

Page: 747 / 788

Meaning
Table 158 on page 707 lists the show profile command output fields.
Table 158: show profile Output Fields
Field Description Field Name
Name of input policy and whether statistics are
enabled or disabled Input Policy
Name of output policy and whether statistics are
enabled or disabled Output Policy
Name and value of the QoS parameter assigned to
the profile qos-parameter
Name of the QoS profile assigned to the profile qos-profile
Related Topics
■
show profile
Monitoring IPv4 and IPv6 Interfaces for Service Manager
Purpose
Display status information about the IP and IPv6 interfaces.
Action
To display information about a specific IP interface.
host1# show ip interface gigabitEthernet 1/1.200
GigabitEthernet1/1 line protocol Ethernet is up, ip is not present
Network Protocols: IP
Multipath mode = hashed
Auto Configure = disabled
Auto Detect = disabled
Inactivity Timer = disabled
Use Framed Routes = disabled
ARP spoof checking = disabled
Warm-restart initial-sequence-preference: Operational = 0 Administrative = 0
In Received Packets 0, Bytes 0
Unicast Packets 0, Bytes 0
Multicast Packets 0, Bytes 0
In Policed Packets 0, Bytes 0
In Error Packets 0
In Invalid Source Address Packets 0
In Discarded Packets 0
Out Forwarded Packets 0, Bytes 0
Unicast Packets 0, Bytes 0
Multicast Routed Packets 0, Bytes 0
Out Scheduler Dropped Packets 0, Bytes 0
Out Policed Packets 0, Bytes 0
Out Discarded Packets 0
queue 0: traffic class best-effort, bound to ip GigabitEthernet1/1
Queue length 0 bytes
Monitoring IPv4 and IPv6 Interfaces for Service Manager
■ 707
Chapter 28: Monitoring Service Manager