Juniper JUNOSE 11.0.X MULTICAST ROUTING, Configuration Manual

Page: 222 / 788

Table 41: AAA Accounting Tunnel Message RADIUS Attributes Supported
(continued)
Acct-Tunnel-
Link-Reject Acct-Tunnel-
Link-Stop Acct-Tunnel-
Link-Start Acct-Tunnel-
Reject Acct-Tunnel-
Stop Acct-Tunnel-
Start
Attribute Name
Attribute
Number
✓ ✓
–
✓ ✓
– Acct-Terminate-Cause [49]
✓ ✓ ✓ ✓ ✓ ✓
Event-Timestamp [55]
✓ ✓ ✓ ✓ ✓ ✓
Tunnel-Type [64]
✓ ✓ ✓ ✓ ✓ ✓
Tunnel-Medium-Type [65]
✓ ✓ ✓ ✓ ✓ ✓
Tunnel-Client-Endpoint [66]
✓ ✓ ✓ ✓ ✓ ✓
Tunnel-Server-Endpoint [67]
✓ ✓ ✓ ✓ ✓ ✓
Acct-Tunnel-
Connection [68]
✓ ✓ ✓ ✓ ✓ ✓
Tunnel-Assignment-Id
(LAC only) [82]
✓ ✓ ✓
– – – Tunnel-Preference
(LAC only) [83]
✓ ✓
– – – – Acct-Tunnel-Packets-
Lost [86]
✓ ✓ ✓ ✓ ✓ ✓
Tunnel-Client-Auth-Id [90]
✓ ✓ ✓ ✓ ✓ ✓
Tunnel-Server-Auth-Id [91]
DSL Forum VSAs in AAA Access and Accounting Messages
JUNOSe software supports the inclusion of a set of DSL Forum vendor-specific
attributes (VSAs) in the following AAA access and accounting messages:
■
Access-Request
■
Acct-Start
■
Acct-Stop
■
Interim-Acct (if Acct-Stop messages are specified)
The DSL Forum VSAs convey information about the subscriber associated with the
digital subscriber line (DSL) and the data rate of the DSL. When you use “radius
include dsl-forum-attributes” on page 232 to enable inclusion of the DSL Forum VSAs
in these AAA messages, the router includes all of the attributes listed in Table 42 on
page 183 in the specified message, provided that the VSA is available in the information
that the router receives from the digital subscriber line access multiplexer (DSLAM).
182 ■
DSL Forum VSAs in AAA Access and Accounting Messages
JUNOSe 11.0.x Broadband Access Configuration Guide