Juniper JUNOSE 11.0.X MULTICAST ROUTING, Configuration Manual

Page: 254 / 788

■
radius include tunnel-server-attributes
radius include tunnel-server-attributes
■
Use to include all supported tunnel server attributes in Access-Request, Acct-Start,
or Acct-Stop messages.
■
When the router functions as an LNS with a terminating PPP, then the LAC tunnel
attributes are included.
■
You can control inclusion of all tunnel server attributes by enabling or disabling
this command.
■
See radius include
■
Example
host1(config)# radius include tunnel-server-attributes access-request enable
■
Use the no version to restore the default, disable.
Juniper Networks Vendor-Specific Attributes
This section describes the Juniper Networks vendor-specific attributes (VSAs) that
you can configure using CLI commands. The attributes are listed numerically and
are followed by descriptions about the commands that you can use to manage the
attribute.
[26-1] Virtual-Router
Use the following command to manage the Virtual-Router RADIUS attribute.
■
radius ignore virtual-router
radius ignore virtual-router
Use to cause the Virtual-Router attribute to be ignored in Access-Accept messages.
■
■
You can control this behavior by enabling or disabling this command.
■
See radius ignore
■
Example
host1(config)# radius ignore virtual-router enable
■
Use the no version to restore the default, disable.
[26-10] Ingress-Policy-Name
Use the following commands to manage the Ingress-Policy-Name RADIUS attribute.
■
radius include ingress-policy-name
■
radius ignore ingress-policy-name
214 ■
CLI Commands Used to Modify RADIUS Attributes
JUNOSe 11.0.x Broadband Access Configuration Guide