Juniper JUNOSE 11.0.X MULTICAST ROUTING, Configuration Manual

Page: 71 / 788

■
Use to issue an administrative reset to the user’s connection to disconnect the
user.
■
From Privileged Exec mode, you can log out all subscribers, or log out subscribers
by username , domain , virtual-router , port , or icr-partition .
■
This command applies to PPP users, as well as to non-PPP DHCP users.
■
Example
host1# logout subscribers username bmurphy
■
There is no no version.
■
See logout subscribers
max-sessions
■
Use to configure the number of outstanding requests supported by an
authentication or accounting server.
■
If the request limit is reached, the router sends the request to the next server.
NOTE: For information about the number of concurrent RADIUS requests that the
router supports for authentication and accounting servers, see JUNOSe Release Notes ,
Appendix A , System Maximums .
■
The same IP address can be used for both an authentication and accounting
server (but not for multiple servers of the same type). The router uses different
UDP ports for authentication servers and accounting servers.
■
For each multiple of 255 requests (the RADIUS protocol limit), the router opens
a new UDP source (or local) port on the server to send and receive RADIUS
requests and responses.
■
Example
host1(config)# radius authentication server 10.10.0.1
host1(config-radius)# max-sessions 100
■
Use the no version to restore the default value, 255.
■
See max-sessions.
no radius client
■
Use to remove all RADIUS servers for the virtual router context and to delete the
E Series RADIUS client for the virtual router context.
■
Example
host1:boston(config)# no radius client
■
There is no affirmative version of this command; there is only a no version.
■
See no radius client
Configuring RADIUS Authentication and Accounting Servers
■ 31
Chapter 1: Configuring Remote Access