Juniper JUNOSE 11.0.X MULTICAST ROUTING, Configuration Manual

Page: 101 / 788

■
DHCP relay proxy
■
DHCP local server
■
DHCP external server
For more information about DHCP, see “DHCP Overview Information” on page 455.
Creating an IP Interface
You can configure IP interfaces that support the following configurations:
■
A single PPP client per ATM or Frame Relay subinterface
■
Multiple PPP clients per ATM subinterface
Single Clients per ATM Subinterface
Figure 3 on page 61 shows a conceptual view of the configuration of a single PPP
client per ATM subinterface.
Figure 3: Single PPP Clients per ATM Subinterface
Configure an ATM interface by entering Configuration mode and performing the
following tasks. For more information about configuring ATM interfaces, see
JUNOSe
Link Layer Configuration Guide .
1.
Configure a physical interface.
host1(config)# interface atm 0/1
2.
Configure the subinterface.
host1(config-if)# interface atm 0/1.20
3.
Configure a permanent virtual circuit (PVC) by specifying the vcd (virtual circuit
descriptor), the vci (virtual channel identifier), the vpi (virtual path identifier),
and the encapsulation type.
host1(config-if)# atm pvc 10 22 100 aal5snap
4.
Configure PPP encapsulation.
host1(config-if)# encapsulation ppp
Creating an IP Interface
■ 61
Chapter 1: Configuring Remote Access