Juniper JUNOSE 11.0.X MULTICAST ROUTING, Configuration Manual

Page: 455 / 788

l2tp dial-out session delete
■
Use to delete a dial-out session.
■
Closes any L2TP outgoing call associated with the dial-out session.
■
Example
host1# l2tp dial-out session delete 10.10.0.0
■
There is no no version.
■
See l2tp dial-out session delete
l2tp dial-out session reset
■
Use to force the dial-out session to the dormant state where it remains until the
dormant timer expires or it receives a new trigger.
■
Closes any L2TP outgoing call associated with the dial-out session.
■
Example
host1# l2tp dial-out session reset 10.10.0.0
■
There is no no version.
■
See l2tp dial-out session reset
l2tp dial-out target
■
Use to define an L2TP dial-out target. When the router receives packets destined
for the target, it creates a dial-out session.
■
When you create a target, you must specify the following:
■
ipAddress —IP address of the target
■
ipAddressMask —IP address mask of the target
■
domainName —Domain name used in the outgoing call Access-Request
message
■
profileName —Name of profile used to create the interface stack
■
Example
host1(config)# l2tp dial-out target 10.10.0.0 255.255.0.0 L2TP-dial-out.de.dt
profile dialOut
■
Use the default version to remove the L2TP dial-out route.
■
Use the no version to remove the L2TP dial-out route or target.
■
See l2tp dial-out target
Monitoring L2TP Dial-Out
To monitor L2TP dial-out, see:
Monitoring L2TP Dial-Out
■ 415
Chapter 14: Configuring L2TP Dial-Out