Juniper JUNOSE 11.0.X MULTICAST ROUTING, Configuration Manual

Page: 733 / 788

■
Use to allow only subscribers on the specified standard IP access list to connect
to the HTTP local server.
■
Example
host1(config)# ip http access-class chicagoList
■
Use the no version to remove the association between the access list and the
HTTP local server.
■
See ip http access-class
ip http max-connection-time
■
Use to specify the maximum time that the HTTP local server maintains an inactive
connection.
■
Specify a time in the range 3–7200 seconds, or 0. A value of 0 causes the server
to maintain an inactive connection indefinitely.
■
Example
host1(config)# ip http max-connection-time 1000
■
Use the no version to restore the default time, 30 seconds.
■
See ip http max-connection-time
ip http port
■
Use to specify the port on which the HTTP local server receives connection
attempts for IPv4 exception packets.
■
Specify a port number in the range 1–65535.
■
Example
host1(config)# ip http port 8080
■
Use the no version to restore the default port number, 80.
■
See ip http port
ip http redirectUrl
■
Use to specify the URL to which a subscriber’s HTTP access session is redirected.
■
The first access session is typically used by the Service Manager application to
provide initial provisioning and service selection for the subscriber.
■
HTTP redirect is per-interface; use the command in Profile Configuration mode
for dynamic interfaces; use the command in Interface Configuration mode or
Subinterface Configuration mode for static interfaces.
■
The redirect URL can be a maximum of 64 characters.
Service Definition Examples
■ 693
Chapter 27: Configuring Service Manager