Juniper JUNOSE 11.0.X MULTICAST ROUTING, Configuration Manual

Page: 249 / 788

■
Use to specify whether the router includes the subinterface number or adapter
in the interface description it passes to RADIUS for inclusion in the NAS-Port-Id
attribute. By default, the subinterface and adapter are sent (the commands are
enabled).
■
Examples
host1# aaa intf-desc-format include sub-intf disable
host1# aaa intf-desc-format include adapter enable
■
Use the no version to remove the configuration.
■
See aaa intf-desc-format include
radius include nas-port-id
Use to include the NAS-Port-Id attribute in the Access-Request, Acct-Start, or
Acct-Stop messages.
■
■
You can control inclusion of the NAS-Port-Id attribute by enabling or disabling
this command.
■
See radius include
■
Example
host1(config)# radius include nas-port-id access-request enable
■
Use the no version to restore the default, enable.
radius override nas-port-id remote-circuit-id
Use to configure RADIUS to override the standard use of the NAS-Port-Id attribute
and instead use the remote circuit ID transmitted from a DSLAM device.
■
■
See radius override nas-port-id remote-circuit-id
■
Example
host1(config)# radius override nas-port-id remote-circuit-id
■
Use the no version to restore the default NAS-Port-ID value, which is the physical
interface of the NAS that is authenticating the user.
Related Topics
Monitoring Override Settings of RADIUS IETF Attributes on page 297
■
■
Monitoring the NAS-Port-ID RADIUS Attribute on page 301
[90] Tunnel-Client-Auth-Id
Use the following command to manage the Tunnel-Client-Auth-Id RADIUS attribute.
CLI Commands Used to Modify RADIUS Attributes
■ 209
Chapter 3: Configuring RADIUS Attributes