Juniper JUNOSE 11.0.X MULTICAST ROUTING, Configuration Manual

Page: 72 / 788

radius accounting server
■
Use to specify the IP address of authentication and accounting servers.
■
Example
host1(config)# radius authentication server 10.10.10.1
host1(config-radius) exit
host1(config)# radius authentication server 10.10.10.2
host1(config-radius) exit
host1(config)# radius authentication server 10.10.10.3
host1(config-radius) exit
host1(config)# radius accounting server 10.10.10.20
host1(config-radius) exit
host1(config)# radius accounting server 10.10.10.30
■
Use the no version to delete the instance of the RADIUS server.
■
See radius accounting server
radius algorithm
■
Use to specify the algorithm—either direct or round-robin —that the E Series
RADIUS client uses to contact the RADIUS server.
■
The algorithm that you choose impacts the display status of a RADIUS server.
For information on the effect of the algorithm configuration on the display of
the
show radius servers command, see “Monitoring RADIUS Server Information”
on page 141
■
Example
host1(config)# radius algorithm round-robin
■
Use the no version to set the algorithm to the default, direct .
■
See radius algorithm
radius override nas-info
■
Use to configure the RADIUS client to include the NAS-IP-Address [4] and
NAS-Identifier [32] RADIUS attributes of the authenticating virtual router in
accounting packets when the client performs AAA broadcast accounting.
Normally, the accounting packets include the NAS-IP-Address and NAS-Identifier
of the virtual router that generated the accounting information.
■
This override operation is a per-virtual router specification; use this command
in the correct virtual router context.
■
This command is ignored if the authenticating virtual router does not have a
configured RADIUS server.
■
Example
host1(config)# virtual-router vrXyz1
host1:vrXyz1(config)# radius override nas-info
host1:vrXyz1(config)# exit
32 ■
Configuring RADIUS Authentication and Accounting Servers
JUNOSe 11.0.x Broadband Access Configuration Guide