Juniper JUNOSE 11.0.X MULTICAST ROUTING, Configuration Manual

Page: 65 / 788

15.
(Optional) Specify the default authentication and accounting methods for the
subscribers.
host1(config)# aaa authentication ppp default radius none
16.
(Optional) Disable UDP checksums on virtual routers you configure for B-RAS.
host1:(config)# virtual router boston
host1:boston(config)# radius udp-checksum disable
aaa accounting broadcast
■
Use to enable AAA broadcast accounting on a virtual router. Specifies that
accounting records be sent to the accounting servers on the virtual routers in
the named virtual router group.
■
A virtual router group can be used in any virtual router context, not just the
context in which it is created.
■
Example
host1(config)# virtual-router vrSouth25
host1:vrSouth25(config)# aaa accounting broadcast westVrGroup38
host1:vrSouth25(config)# exit
■
Use the no version to disable the AAA broadcast accounting.
■
See aaa accounting broadcast
aaa accounting default
■
Use to specify the accounting method used for a particular type of subscriber.
■
Specify one of the following types of subscribers:
■
atm1483 ; this keyword is not supported
■
tunnel
■
ppp
■
radius-relay
■
ipsec
■
ip (IP subscriber management interfaces)
NOTE: IP subscriber management interfaces are static or dynamic interfaces that
are created or managed by the JUNOSe software’s subscriber management feature.
Although the atm1483 keyword is available in the CLI for this command, that
subscriber type is not supported. The router does not support accounting for ATM
1483 subscribers.
■
Specify one of the following types of accounting methods:
Configuring RADIUS Authentication and Accounting Servers
■ 25
Chapter 1: Configuring Remote Access