Juniper JUNOSE 11.0.X MULTICAST ROUTING, Configuration Manual

Page: 412 / 788

NOTE: When acting as the LNS, the E Series router supports dialed number
identification service (DNIS). With DNIS, if users have a called number associated
with them, the router searches the domain map for the called number. If it finds a
match, the router uses the matching domain map entry information to authenticate
the user. If the router does not find a match, it searches the domain map using normal
processing. See “Using DNIS” on page 9 in “Configuring Remote Access” on page 3.
Related Topics
■
Creating an L2TP Destination Profile on page 372
■
Creating an L2TP Host Profile on page 373
■
Configuring the Maximum Number of LNS Sessions on page 374
■
Configuring the RADIUS Connect-Info Attribute on the LNS on page 374
■
Overriding LNS Out-of-Resource Result Codes 4 and 5 on page 375
■
Selecting Tunnel-Service Modules for LNS Sessions Using MLPPP on page 376
■
bundled-group-id
■
bundled-group-id-overrides-mlppp-ed
■
default-upper-type mlppp command
■
disable proxy lcp
■
enable proxy authenticate
■
l2tp destination profile
■
local host
■
local ip address command
■
max-sessions
■
radius connect-info-format
■
remote host
■
session-out-of-resource-result-code-override
■
tunnel password
Creating an L2TP Destination Profile
You use the l2tp destination profile command to create the destination profile that
defines the location of the LAC, and to access L2TP Destination Profile Configuration
mode.
If no virtual router is specified with the command, the current virtual router context
is used.
372 ■
Creating an L2TP Destination Profile
JUNOSe 11.0.x Broadband Access Configuration Guide