MAP 0100: Start of Service Call
Check Status
of:
Issue Commands on:
Commands:
SP hardware
Control workstation
errpt -a -N sphwlog | pg
Affected node
Node's TTY console or "tn
HOSTNAME"
errpt -a | pg
Switch links
Primary node's TTY console or "tn
HOSTNAME" (use splstdata -s to identify
HOSTNAME)
errpt -a -N Worm | pg
pg /var/adm/SPlogs/css/out.top
Dependent
node
Control workstation
SDRGetObjects DependentNode
Notes:
1. The most recent entry is found at the
top of errpt
2. When viewing the error log using the pg command, the following options may be entered at the
colon (:) prompt:
$
Jumps to end of output (to view oldest entries of errpt
+
Jumps one page forward
−
Jumps one page backward
#
Jumps to line number # of the file (first line is 1)
3. Refer to "Checking Errors Using “errpt”" in
IBM RS/6000 SP: Maintenance Information, Volume 3,
Locations and Service Procedures for more information on using the errpt command.
4. Check the date/time stamp of the log entries for updated information. Be aware that conditions may
have been cleared, as indicated by “Condition cleared” in the message.
5. Note that “node17” or “slot17” refers to a switch assembly in the position below processor nodes 1
and 2.
– The following table contains a prioritized list of conditions. Find the first condition that describes your
problem, then perform the suggested action.
Priority
Condition
Action
1
Control workstation hardware not
operating correctly.
Go to RS/6000 MAPs to service the control work-
station.
2
System monitor (errpt) reports super-
visor problem:
“Frame Controller does not
respond...”
“Frame supervisor does not
respond”
“Supervisor bus failed for node...”
“Node supervisor does not
respond”
“Supervisor bus failure”
Perspectives/spmon not
responding to frame or node
Go to “MAP 0110: Supervisor Subsystem” on
page 1-10.
3
Problem with entire frame:
System monitor (errpt/not
topology) reports hardware
problem associated with frame(s).
Problem with frame power.
Go to “MAP 0370: Main Power” on page 1-222.
1-6
RS/6000 SP MAPs
Summary of Contents for RS/6000 SP
