MAP 0180: Thin Processor Node DC Short/Open
006 (continued)
– Reinstall processor node, then power on the processor node from the control console.
Does this fix the problem?
Yes No
007
Problem still exists.
– Go to Step 009.
008
This adaptor was causing problem.
– Call next level of support.
009
– Clip multimeter leads to the connector pins of N00-PL-J2 for the voltage that shows resistance out of
range.
– Remove affecting components (see chart below) until all components have been removed or resistance
enters acceptable range.
Note: Parts are ordered by probable cause of failure. ‘X’ indicates voltage is used.
The following table refers to I/O Planar jack N00-PL-J2:
Voltage
Measure From
(positive lead)
To GND
(negative lead)
Acceptable Range
+5 V dc
Pin 1 (red)
Pin 2 (black)
5 - 30 Ohms
+12 V dc
Pin 3 (yellow)
Pin 2 (black)
100 - 5000 Ohms
−
12 V dc
Pin 9 (purple)
Pin 2 (black)
500 - 900 Ohms
#
Component
+5 V dc
+12 V dc
−
12 V dc
1
CPU card (Thin node or thin node 2)
X
2
Memory card (slot A)
X
3
Memory card (slot B)
X
4
Micro Channel card (slot 1)
X
X
X
5
Micro Channel card (slot 2)
X
X
X
6
Micro Channel card (slot 3)
X
X
X
7
Micro Channel card (slot 4)
X
X
X
8
Ethernet riser card
X
X
X
9
Fixed disk drive(s)
X
X
(Step 009 continues)
Chapter 1. Maintenance Analysis Procedures (MAPs)
1-85
Summary of Contents for RS/6000 SP
